Instructions / Assembly

MODEL NO.: 20074

CAUTION: Be sure outlet box is grounded properly and that a

ground wire (green or bare) is present.

Partially loosen screws in slotted holes of canopy.

Remove the other 2 screws (along with the star

washers) -save for later use. Twist canopy to

remove the hanging bracket.

Install hanging bracket to outlet box using original

screws,

spring washers and flat washers provided with

new or original outlet box. If installing on a vaulted

ceiling, face opening of Hanging Bracket towards high

point of ceiling. Arrange electrical wiring around the

back of the hanging bracket and away from the hanging

bracket opening.

CAUTION: It is very important that you use the proper

hardware when installing the hanging bracket as this will

support

the weight of the fan.

ELECTRICAL OUTLET BOX

WARNING: Contact a qualified electrician to replace the outlet box if it is not suitable for ceiling fans

1. If there is an existing outlet box, ensure it is clearly marked “Suitable For Fan Support”.

If not, it must be replaced with an approved one.

2. Secure the outlet box (or make sure the existing box is secured) directly

to the building structure. Use appropriate fasteners and building

materials. Wood joist

and outlet box must be able to support a minimum

of 50 pounds.

3. Figure 1, 2 and 3 are examples of different ways to mount the outlet

box in different situations.

4. To hang the fan in locations where no ceiling joists is available. A hanger

support

bar may be required (Fig. 4)