Owner's manual

Assemble the belt on the front & rear pulley and
holding them as a unit, slide them onto the
motor sprocket shaft and transmission main-
shaft at the same time. (See figure 15).
It may be necessary to work the pulleys a little
bit at a time to walk them onto the shafts.
(See figure 16 & 17).
Put 4-5 drops of blue thread locker on front pul-
ley bolt then insert the bolt and cup washer into
the front pulley and torque to specs found in
your OE manual.(See figure 18).
Put 2-3 drops of blue thread locker on the trans
mainshaft, then thread the clutch hub nut onto
the shaft. See figure 19).
NOTE: The clutch hub nut is left hand thread.
Holding the hub with Rivera’s PC-3000 clutch hub
holder tool, torque the left hand threaded clutch
hub nut 80-90 ft. lbs. (See figure 20).
Figure 15
Figure 17
Figure 16
Figure 18
Figure 19
Figure 20