Manual

DO NOT OPERATE

this or any other Rivera Primo Inc. open-primary belt-drive without the proper safety guard or belt cover in place. A well designed

belt guard actually adds to the appearance of the motorcycle while protecting you as well as the belt drive from incidental

damage caused by rocks or debris between the belt and the pulleys. Be safe, always use a belt guard!

YOUR A TTENTION PLEASE!!

STEP 16:

TIGHTEN THE SHOULDERED NUTS

EQUALLY UNTIL THEY BOTTOM, AND

THEN TIGHTEN TO 30 INCH POUNDS

(NOT FOOT POUNDS) OF TORQUE.

Install the clutch adjustment screw &

adjust the clutch following factory proce-

dures as found the Harley-Davidson ser-

vice manual. Bend the lock tabs over to

prevent the nuts from coming loose.

Note: Never use Loctite on these threads

STEP 17:

Install the starter support housing (over the starter extender

mechanism) as pictured. Carefully locate the housing to align

the bolts. Check to make sure the starter can turn freely as the

bolts are tightened. TORQUE TO 29 FOOT POUNDS.

STEP

18 & 18A

This is what your installation should look like.

Be sure & install either the belt guard that

came with the kit, or one of Rivera Primo

Inc.’s optional belt guards.

To check belt tension grasp the top belt and

move up and down. It should have approxi-

mately 3/4” of total movement with a cold

drive train.

18A

A belt guard is included with all Brute IV

kits.

Using one(1) drop of “red” threadlock or equivalent

on each fastener, bolt the belt guard to the stand-

off studs using the supplied 5/16” buttonheads &

TORQUE TO 29 FOOT POUNDS.