User Manual Part 1

Wi-Fi Array
Viewing Status on the Wi-Fi Array 125
• Link: Shows whether the link on this interface is up or down.
• DHCP: Shows whether DHCP on this port is enabled or disabled.
• IP Address: Shows the current IP address assigned to each network
interface device.
• Subnet Mask: Shows the subnet mask, which defines the number of
IP addresses that are available on the routed subnet where the Array
is located.
• Gateway: Shows the IP address of the router that the Array uses to
transmit data to other networks.
 Integrated Access Points Section
This section provides information about the Integrated Access Points
(IAPs) that are contained within the Array. How many IAPs are listed
depends on which product model you are using (16 IAPs for the XN16 or
XS16; 12 IAPs for the XN12; 8 IAPs for the XR 48xx or XN8 or XS8; and 4
IAPs for the XR 44xx or XN4 or XS4). To make configuration changes to
these IAPs, go to “IAP Settings” on page 271.
• IAP: Lists the IAPs that are available on the Array.
• State: Shows the current state of each IAP, either up or down. IAPs
that are down are shown in RED. Figure 47 shows an example where
IAP a3 is down.
Figure 47. Disabled IAP (Partial View)
• Channel: Shows which channel each IAP is using, and the channel
setting. To avoid co-channel interference, adjacent radios should not