User Manual Part 2

Wi-Fi Array
372 The Command Line Interface
management
The management command [Xirrus_Wi-Fi_Array(config)# management] enters
management mode, where you may configure management parameters.
The following types of settings may be configured in management mode:
 console Configure console management parameters
 fips Enable/disable FIPS 140-2, Level 2 Security. 
See Appendix E: Implementing FIPS Security
 https Enable/disable HTTPS access
 license Set array software license key
 load Load running configuration from flash
 network-assurance Enable/disable network assurance
 pci-audit Enable/disable PCI (Payment Card Industry)
audit mode. 
See “The pci-audit Command” on page 458.
 restore Restore to previous saved config
 save Save running configuration to flash
 ssh Enable/disable SSH access
 standby Configure standby parameters
 telnet Enable/disable telnet access
Command Description
<cr> Enter management mode.
FORMAT:
management <cr>