User Manual Part 2

Wi-Fi Array
196 Configuring the Wi-Fi Array
2. Wi-Fi Tag UDP Port: If you enabled Wi-Fi tagging, enter the port on the
Array which the Wi-Fi tagging server will use to query the Array for
tagging data. When queried, the Array will send back information on the
tags it has observed. For each, the Array sends information such as the
MAC address of the tag transmitting device, and the RSSI and noise floor
observed.
3. Wi-Fi Tag Channel: If you enabled Wi-Fi tagging, enter the 802.11
channel on which the Array will listen for tags. The tag devices must be
set up to transmit on this channel. Only one channel may be configured,
and it must be an 802.11b/g channel in the range of Channel 1 to 11.
System Log
This window allows you to enable or disable the Syslog server, define primary,
secondary, and tertiary servers, set up email notification, and set the level for
Syslog reporting for each of the servers and for email notification — the Syslog
service will send Syslog messages that are at the selected severity or above to the
defined Syslog servers and email address.
Figure 99. System Log