User Guide Part 2

Wi-Fi Array
342 The Command Line Interface
pci-audit
The pci-audit command [Xirrus_Wi-Fi_Array(config)# pci-audit] checks the
configuration of the Array for conformance with PCI DSS standards. When you
enter the pci-audit command, it lists any settings that violate PCI DSS
requirements. In addition, if pci-audit is on (enabled), the Array will warn you if
you change any parameters in a way that violates PCI DSS requirements. For
example, if you enable pci-audit and then set encryption to none on an SSID (in
the CLI or the WMI), a warning will be displayed and a Syslog message will be
issued. For more information, see Appendix D: Implementing PCI DSS.
Command Description
disable The Array will not check configuration changes
for PCI DSS violations.
FORMAT:
pci-audit disable
enable The Array reports any current settings that violate
PCI DSS, and will warn you and issue a Syslog
message if you attempt to save configuration
changes that violate PCI DSS.
FORMAT:
pci-audit enable
off The Array will not check configuration changes
for PCI DSS violations.
FORMAT:
pci-audit off
on The Array reports any current settings that violate
PCI DSS, and will warn you and issue a Syslog
message if you make configuration changes that
that violate PCI DSS.
FORMAT:
pci-audit on