User Guide Part 2

Wi-Fi Array
Appendix E: Implementing FIPS Security 431
7. In the IAPs/Global Settings window, select Off for Fast Roaming. Click
Apply, then Save.
Figure 196. IAPs/Global Settings Screen
To check if an Array is in FIPS mode:
You may determine whether or not the Array is running in FIPS mode by
verifying that the settings described in the previous procedure are in effect.
To implement FIPS 140-2, Level 2 using CLI:
1. The following CLI command will perform all of the settings required to
put the Array in FIPS mode:.
Xirrus_Wi-Fi_Array(config}# fips on
This command remembers your previous settings for FIPS-related
attributes. They will be restored if you use the fips off command.
Use the save command to save these changes to flash memory.
2. Use the fips off command if you would like to revert the FIPS settings
back to the values they had before you entered the fips on command.
Xirrus_Wi-Fi_Array(config}# fips off
Use the save command to save these changes to flash memory.