Quick Install Guide

XR-2425H Quick Installation Guide
- 13 -
Warnings
GENERAL SAFETY GUIDELINES
WARNING: This warning symbol means danger. You are in a situation that could
cause bodily injury. Before you work on any equipment, be aware of the hazards
involved with electrical circuitry and be familiar with standard practices for
preventing accidents.
WARNING: Only trained and qualified personnel should be allowed to install,
replace, or service this equipment.
WARNING: Ultimate disposal of this product should be handled according to all
national laws and regulations.
WARNING: Incorrect installation of Xirrus Arrays may invalidate FCC, CE mark, or
other regulatory compliance approvals. Customers are responsible for any legal
violations from operation of un-approved equipment or incorrect installation.
WARNING: Do not operate the Array near unshielded blasting caps or in an
explosive environment unless the device has been modified to be especially qualified
for such use.
CAUTION: Supplied watertight adapters must be used on all input/output
connections to the Array.
POWER
WARNING: Read the installation instructions before connecting the system to the
power source.
WARNING: Installation of the equipment must comply with local and national
electrical codes.
WARNING: This equipment must be externally grounded using a customer-supplied
ground wire before power is applied. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available.
WARNING: Do not work on the system or connect or disconnect cables during periods
of lightning activity.
WARNING: To ensure proper PoE power is delivered to the Array, use only No. 26
AWG or larger Ethernet (Shielded CAT5E, CAT6) cable.
CAUTION: When the Array is installed outdoors or in a wet or damp location, the AC
branch circuit that is powering the Injector should be provided with ground fault
protection (GFCI), as required by Article 210 of the National Electrical Code (NEC).