Quick Install Guide
Table Of Contents
- 1) You Need the Following Items
- 2) Choose a Suitable Location
- 3) Prepare a Ground Source
- 4) Attach the Mounting Plate to the Array
- 5) Mount the Array on a Pole or Wall
- 6) Ground to Earth Ground
- 7) Install Antennas
- 8) Connect the Ethernet Cable with the Waterproof Connector
- 9) Connect the Antenna
- 10) Zero-Touch Provisioning and Ongoing Management
- Dimensions
- Notices, Warnings, & Compliance Statements
XR-2425H Quick Installation Guide
- 19 -
WEEE Compliance: Natural resources were used in the production of this equipment.
This equipment may contain hazardous substances that could impact
the health of the environment.
If you need more information on collection, re-use and recycling
systems, please contact your local or regional waste administration.
Please contact Xirrus for specific information on the environmental
performance of our products.
National Restrictions: In the majority of the EU and other European countries, the 2.4 GHz and
5 GHz bands have been made available for the use of Wireless LANs. The following table
provides an overview of the regulatory requirements in general that are applicable for the 2.4
GHz and 5 GHz bands.
*Dynamic frequency selection and Transmit Power Control is required in these frequency bands.
**France is indoor use only in the upper end of the band.
The requirements for any country may change at any time. Xirrus recommends that you check
with local authorities for the current status of their national regulations for both 2.4 GHz and 5
GHz wireless LANs. The following countries have additional requirements or restrictions than
those listed in the above table:
Belgium: The Belgian Institute for Postal Services and Telecommunications (BIPT) must be
notified of any outdoor wireless link having a range exceeding 300 meters. Xirrus recommends
checking at www.bipt.be for more details.
Draadloze verbindingen voor buitengebruik en met een reikwijdte van meer dan 300 meter dienen
aangemeld te worden bij het Belgisch Instituut voor postdiensten en telecommunicatie (BIPT). Zie
www.bipt.be voor meer gegevens.
Les liasons sans fil pour une utilisation en extérieur d’une distance supérieure à 300 mèters doivent être
notifiées à l’Institut Belge des services Postaux et des Télécommunications (IBPT). Visitez www.bipt.be
pour de plus amples détails.
Greece: A license from EETT is required for the outdoor operation in the 5470 MHz to 5725
MHz band. Xirrus recommends checking www.eett.gr for more details.