User's Guide

Wireless Array
Configuring the Wireless Array 265
Note the following details of the operation of this feature:
z
The list is configured on a per-SSID basis. You must have WPR enabled
for the SSID to see this section of the SSID Management page.
z
When a station that has not yet passed the WPR login/splash page
attempts to access one of the white-listed addresses, it will be allowed
access to that site as many times as requested.
z
The station will still be required to pass through the configured WPR flow
for all other Internet addresses.
z
The whitelist will work against all traffic -- not just http or https
z
Indirect access to other web sites is not permitted. For example, if you
add www.yahoo.com to the whitelist, you can see that page, but not all
the ads that it attempts to display.
z
The whitelist feature does not cause traffic to be redirected to the whitelist
addresses.
WPA Configuration Settings
If you set Encryption for this SSID to one of the WPA selections (Step 11 on
page 256) and you did not check the Global checkbox (Step 12), this section will
be displayed. The WPA Configuration encryption settings have the same
parameters as those described in “Procedure for Configuring Network Security”
on page 231
RADIUS Configuration Settings
The RADIUS settings section will be displayed if you set Authentication (Step 10
on page 255) to RADIUS MAC and you did not check the Global checkbox (Step
12). This means that you wish to set up a RADIUS server to be used for this
particular SSID. If Global is checked, then the security settings (including the
RADIUS server, if any) established at the global level are used instead (see
“Global Settings” on page 230).
The RADIUS and accounting settings are configured in the same way as for an
external RADIUS server (see “Procedure for Configuring an External RADIUS
Server” on page 235).