User's Guide

Wireless Array
Viewing Status on the Wireless Array 93
Content of the Array Summary Window
The Array Summary window is sub-divided into the Ethernet Interfaces section
and the Integrated Access Points (radio) section, providing you with the
following information:
z
Ethernet Settings Summary
This section provides information about network interface devices. To
make configuration changes to these devices, go to “Network Interfaces”
on page 167.
• Interface: Lists the network interfaces that are available on the Array.
• State: Shows the current state of each interface, either enabled or
disabled.
• Mgmt: Shows whether Array management traffic is allowed on this
interface.
• Auto Neg: Shows whether auto-negotiation is in use on this interface,
to determine settings for speed, parity bits, etc.
• LED: Shows whether LED display of interface status is enabled.
• Link: Shows whether the link on this interface is up or down.
• Duplex: Shows whether full duplex mode is in use.
• Speed: Shows the speed of this interface in Mbps.
• MTU Size: Shows the Maximum Transmission Unit size that has
been configured. This is the largest packet size (in bytes) that the
interface can pass along.
• DHCP: Shows whether DHCP on this port is enabled or disabled.
• IP Address: Shows the current IP address assigned to each network
interface device.
• Subnet Mask: Shows the subnet mask, which defines the number of
IP addresses that are available on the routed subnet where the Array
is located.
• Gateway: Shows the IP address of the router that the Array uses to
transmit data to other networks.