User's Manual

Wireless Array
378 The Command Line Interface
network administrator assign a reserved address to the Array for ease
of access in the future.
• If the network does not use DHCP, use the factory default address
10.0.2.1 to access either the Gigabit 1 or Gigabit 2 Ethernet port. You
may need to change the IP address of the port on your computer that
is connected to the Array — change that port’s IP address so that it is
on the same 10.0.2.xx subnet as the Array port.
• If your Array is an 8-, 12-, or 16-port model, it has a 10/100Mb
Ethernet port called Ethernet0. This management port has a default
IP address of 10.0.1.1. You may connect your computer directly to this
port, but you will need to set the IP address of the connected port on
your computer to the 10.0.1.xx subnet.
2. At the login prompt, enter your user name and password (the default for
both is admin). Login names and passwords are case-sensitive. You are
now logged in to the Array’s Command Line Interface.
Figure 184. Logging In