User's Manual

Wireless Array
The Command Line Interface 409
management
The management command [Xirrus_Wi-Fi_Array(config)# management] enters
management mode, where you may configure management parameters.
The following types of settings may be configured in management mode:
 banner Configure login banner messages
 console Configure console management parameters
 https Enable/disable HTTPS access
 license Set array software license key
 load Load running configuration from flash
 max-auth-attempts Maximum number of authentication (login)
attempts (0 means unlimited)
 network-assurance Enable/disable network assurance
 reauth-period Time between failed CLI login attempts
 restore Restore to previous saved config
 revert Revert to saved configuration after delay if
configuration not saved
 save Save running configuration to flash
 ssh Enable/disable SSH access
 standby Configure standby parameters
 telnet Enable/disable telnet access
 uptime Display time since last boot
 xircon Enable/disable xircon access. See Xircon User’s
Guide for more information. Not available for XN Arrays.
Command Description
<cr> Enter management mode.
FORMAT:
management <cr>