User's Manual
Table Of Contents
- XS-3900 User’s Guide
- Front Matter
- Table of Contents
- List of Figures
- Introduction
- Installing the XS-3900
- Installation Prerequisites
- Planning Your Installation
- Installation Workflow
- Unpacking the XS-3900
- Installing the XS-3900
- Powering Up the XS-3900
- Establishing Communication with the Array
- Performing the Express Setup Procedure
- The Web Management Interface
- Configuring the XS-3900
- Logging In
- Making Configuration Changes to the XS-3900
- Array Status
- Express Setup
- Network Interfaces
- IAP Interfaces
- SSID Management
- Security
- Users
- Services
- Software
- Tools
- Event Log
- The Command Line Interface
- Establishing a Secure Shell (SSH) Connection
- Basic Commands
- Command Modes
- Selecting Interfaces
- Command Line Keywords
- Interface Selection
- Interface Configuration
- Radio Configuration
- Beacon Information
- System Administration
- System Testing
- Security
- Station Timeouts
- SSID Configuration
- DNS Configuration
- NTP Configuration
- DHCP Configuration
- Syslog Configuration
- SNMP Configuration
- Filters
- Radius Configuration
- Reports
- Data Handling
- Data Clearance
- Show Information
- Remove Configuration
- Help
- Appendix A: Quick Reference Guide
- Appendix B: Technical Support
- Glossary of Terms
- Index
Wireless LAN Array
124 The Command Line Interface
halfduplex
ip-addr
management
mask
Description: Select the half duplex mode
Usage: <genum> | <fenum> { halfduplex }
Parameters: <genum> defines the Gigabit interface, either 1 or 2, where:
1 = Primary, 2 = Secondary
<fenum> defines the Fast Ethernet interface (must be 0)
Description: Define a static IP address
Usage: <genum> | <fenum> { ip-addr <statip> }
Parameters: <genum> defines the Gigabit interface, either 1 or 2, where:
1 = Primary, 2 = Secondary
<fenum> defines the Fast Ethernet interface (must be zero)
<statip> defines a valid static IP address
Description: Allow management on this interface
Usage: <genum> | <fenum> { management <mgmt> }
Parameters: <genum> defines the Gigabit interface, either 1 or 2, where:
1 = Primary, 2 = Secondary
<fenum> defines the Fast Ethernet interface (must be zero)
<mgmt> selects management or no management, where:
0 = No, 1 = Yes
Description: Define the subnet mask IP address
Usage: <genum> | <fenum> { mask <ipmask> }
Parameters: <genum> defines the Gigabit interface, either 1 or 2, where:
1 = Primary, 2 = Secondary
<fenum> defines the Fast Ethernet interface (must be zero)
<ipmask> defines a valid subnet mask IP address