User's Manual
Table Of Contents
- XS-3900 User’s Guide
- Front Matter
- Table of Contents
- List of Figures
- Introduction
- Installing the XS-3900
- Installation Prerequisites
- Planning Your Installation
- Installation Workflow
- Unpacking the XS-3900
- Installing the XS-3900
- Powering Up the XS-3900
- Establishing Communication with the Array
- Performing the Express Setup Procedure
- The Web Management Interface
- Configuring the XS-3900
- Logging In
- Making Configuration Changes to the XS-3900
- Array Status
- Express Setup
- Network Interfaces
- IAP Interfaces
- SSID Management
- Security
- Users
- Services
- Software
- Tools
- Event Log
- The Command Line Interface
- Establishing a Secure Shell (SSH) Connection
- Basic Commands
- Command Modes
- Selecting Interfaces
- Command Line Keywords
- Interface Selection
- Interface Configuration
- Radio Configuration
- Beacon Information
- System Administration
- System Testing
- Security
- Station Timeouts
- SSID Configuration
- DNS Configuration
- NTP Configuration
- DHCP Configuration
- Syslog Configuration
- SNMP Configuration
- Filters
- Radius Configuration
- Reports
- Data Handling
- Data Clearance
- Show Information
- Remove Configuration
- Help
- Appendix A: Quick Reference Guide
- Appendix B: Technical Support
- Glossary of Terms
- Index
Wireless LAN Array
126 The Command Line Interface
up
Radio Configuration
The following keywords are used when configuring the XS-3900’s radios
(assumes the interface has already been selected).
antenna
antennaexternal
basic1
basic11
basic12
Description: Bring up this interface
Usage: <genum> | <fenum> { up }
Parameters: <genum> defines the Gigabit interface, either 1 or 2, where:
1 = Primary, 2 = Secondary
<fenum> defines the Fast Ethernet interface (must be zero)
Description: Set the direction for this radio antenna
Usage: <rnum> { antenna }
Parameters: <rnum> defines the radio number, between 1 and 16
Description: Show the external antenna settings
Usage: <rnum> { antennaexternal }
Parameters: <rnum> defines the radio number, between 1 and 16
Description: Require 1 Mbps rate
Usage: <rnum> { basic1 }
Parameters: <rnum> defines the radio number, between 13 and 16
Description: Require 11 Mbps rate
Usage: <rnum> { basic11 }
Parameters: <rnum> defines the radio number, between 13 and 16
Description: Require 12 Mbps rate
Usage: <rnum> { basic12 }
Parameters: <rnum> defines the radio number, between 1 and 16