User's Manual

Wireless LAN Array
The Command Line Interface 143
traceroute
Security
The following keywords are used for system security.
all11a
all11g
allradios
broadcastkey
Parameters: <tracename> specifies target IP address or DNS name to trace
<pingname> specifies target IP address or DNS name to ping
<ledtst> specifies the LED to test (defined by LED number, 0 to
9—refer to “Now that the XS-3900 is physically installed, you
must run the Express Setup procedure from the unit’s Web
Management Interface to enable the radios and establish initial
system configuration settings. Go to “Powering Up the XS-
3900” on page 44.” on page 43)
<linktest> specifies the link test, 1 through 4, where:
1 = tbd, 2 = tbd, 3 = tbd, 4 = tbd
Description: Run a trace on an IP route or DNS name
Usage: run-tests { traceroute <tracename> }
Parameters: <tracename> specifies target IP address or DNS name to trace
Description: Specify that any settings will apply to all 802.11a radios
Usage: security { radioid { all11a }}
Parameters: none
Description: Specify that any settings will apply to all 802.11g radios
Usage: security { radioid { all11g }}
Parameters: none
Description: Specify that any settings will apply to all radios
Usage: security { radioid { allradios }}
Parameters: none
Description: Use the encryption key during broadcast