User's Manual
Table Of Contents
- XS-3900 User’s Guide
- Front Matter
- Table of Contents
- List of Figures
- Introduction
- Installing the XS-3900
- Installation Prerequisites
- Planning Your Installation
- Installation Workflow
- Unpacking the XS-3900
- Installing the XS-3900
- Powering Up the XS-3900
- Establishing Communication with the Array
- Performing the Express Setup Procedure
- The Web Management Interface
- Configuring the XS-3900
- Logging In
- Making Configuration Changes to the XS-3900
- Array Status
- Express Setup
- Network Interfaces
- IAP Interfaces
- SSID Management
- Security
- Users
- Services
- Software
- Tools
- Event Log
- The Command Line Interface
- Establishing a Secure Shell (SSH) Connection
- Basic Commands
- Command Modes
- Selecting Interfaces
- Command Line Keywords
- Interface Selection
- Interface Configuration
- Radio Configuration
- Beacon Information
- System Administration
- System Testing
- Security
- Station Timeouts
- SSID Configuration
- DNS Configuration
- NTP Configuration
- DHCP Configuration
- Syslog Configuration
- SNMP Configuration
- Filters
- Radius Configuration
- Reports
- Data Handling
- Data Clearance
- Show Information
- Remove Configuration
- Help
- Appendix A: Quick Reference Guide
- Appendix B: Technical Support
- Glossary of Terms
- Index
Wireless LAN Array
148 The Command Line Interface
wep128
wep40
Station Timeouts
The following keywords are used for establishing STA timeouts.
activity-timeout
reauth-period
sta-timeouts
Description: Use 128 bit WEP encryption
Usage: security { radioid { allradios { encryption { wep128 }}}}
Parameters: none
Description: Use 40 bit WEP encryption
Usage: security { radioid { allradios { encryption { wep40 }}}}
Parameters: none
Description: Set the time period before the XS-3900 flags an inactive station
Usage: sta-timeouts { activity-timeout <at> }
Parameters: <at> specifies the time, in seconds, before the system flags an
inactive STA
Description: Set the period after a station fails to authenticate before
allowing more attempts
Usage: sta-timeouts { reauth-period <ht> }
Parameters: <ht> specifies the time, in seconds, before the next
authentication attempt
Description: Set the station timeouts
Usage: sta-timeouts { activity-timeout <at> | reauth-period <ht> }
Parameters: <at> specifies the time, in seconds, before the system flags an
inactive STA
<ht> specifies the time, in seconds, before the next
authentication attempt