User's Manual
Table Of Contents
- XS-3900 User’s Guide
- Front Matter
- Table of Contents
- List of Figures
- Introduction
- Installing the XS-3900
- Installation Prerequisites
- Planning Your Installation
- Installation Workflow
- Unpacking the XS-3900
- Installing the XS-3900
- Powering Up the XS-3900
- Establishing Communication with the Array
- Performing the Express Setup Procedure
- The Web Management Interface
- Configuring the XS-3900
- Logging In
- Making Configuration Changes to the XS-3900
- Array Status
- Express Setup
- Network Interfaces
- IAP Interfaces
- SSID Management
- Security
- Users
- Services
- Software
- Tools
- Event Log
- The Command Line Interface
- Establishing a Secure Shell (SSH) Connection
- Basic Commands
- Command Modes
- Selecting Interfaces
- Command Line Keywords
- Interface Selection
- Interface Configuration
- Radio Configuration
- Beacon Information
- System Administration
- System Testing
- Security
- Station Timeouts
- SSID Configuration
- DNS Configuration
- NTP Configuration
- DHCP Configuration
- Syslog Configuration
- SNMP Configuration
- Filters
- Radius Configuration
- Reports
- Data Handling
- Data Clearance
- Show Information
- Remove Configuration
- Help
- Appendix A: Quick Reference Guide
- Appendix B: Technical Support
- Glossary of Terms
- Index
Wireless LAN Array
152 The Command Line Interface
ntp
pri-nts
sec-nts
DHCP Configuration
The following keywords are used for establishing the DHCP parameters.
configure
default-lease
dhcp
Description: Enable/disable or configure NTP services
Usage: ntp { enable | disable }
Parameters: none
Description: Establish the primary NTP server IP address or DNS name
Usage: ntp { pri-nts <pntp> }
Parameters: <pntp> specifies the IP address or DNS name (primary)
Description: Establish the secondary NTP server IP address or DNS name
Usage: ntp { sec-nts <sntp> }
Parameters: <sntp> specifies the IP address or DNS name (secondary)
Description: Configure DHCP services
Usage: dhcp { configure { start-ip-range <sipr> }}
Parameters: <sipr> specifies the starting IP address
Description: Define the default lease period
Usage: dhcp { configure { default-lease <defl> }}
Parameters: <defl> specifies the default lease period, in minutes
Description: Enable/disable or configure DHCP services
Usage: dhcp { enable | disable | configure { start-ip-range <sipr> }}
Parameters: <sipr> specifies the starting IP address