User's Manual
Table Of Contents
- XS-3900 User’s Guide
- Front Matter
- Table of Contents
- List of Figures
- Introduction
- Installing the XS-3900
- Installation Prerequisites
- Planning Your Installation
- Installation Workflow
- Unpacking the XS-3900
- Installing the XS-3900
- Powering Up the XS-3900
- Establishing Communication with the Array
- Performing the Express Setup Procedure
- The Web Management Interface
- Configuring the XS-3900
- Logging In
- Making Configuration Changes to the XS-3900
- Array Status
- Express Setup
- Network Interfaces
- IAP Interfaces
- SSID Management
- Security
- Users
- Services
- Software
- Tools
- Event Log
- The Command Line Interface
- Establishing a Secure Shell (SSH) Connection
- Basic Commands
- Command Modes
- Selecting Interfaces
- Command Line Keywords
- Interface Selection
- Interface Configuration
- Radio Configuration
- Beacon Information
- System Administration
- System Testing
- Security
- Station Timeouts
- SSID Configuration
- DNS Configuration
- NTP Configuration
- DHCP Configuration
- Syslog Configuration
- SNMP Configuration
- Filters
- Radius Configuration
- Reports
- Data Handling
- Data Clearance
- Show Information
- Remove Configuration
- Help
- Appendix A: Quick Reference Guide
- Appendix B: Technical Support
- Glossary of Terms
- Index
Wireless LAN Array
The Command Line Interface 153
disable
enable
end-ip-range
max-lease
start-ip-range
Syslog Configuration
The following keywords are used for establishing the Syslog parameters.
buffered
Description: Disable DHCP services
Usage: dhcp { disable }
Parameters: none
Description: Enable DHCP services
Usage: dhcp { enable }
Parameters: none
Description: Define the DHCP server’s ending IP address
Usage: dhcp { configure { end-ip-range <eipr> }}
Parameters: <eipr> specifies the ending IP address
Description: Define the maximum allowable lease period
Usage: dhcp { configure { max-lease <maxl> }}
Parameters: <maxl> specifies the maximum allowable lease period, in
minutes
Description: Define the DHCP server’s starting IP address
Usage: dhcp { configure { start-ip-range <sipr> }}
Parameters: <sipr> specifies the starting IP address
Description: Set the size of the local Syslog file
Usage: syslog { buffered <logfilesz> }
Parameters: <logfilesz> sets the number of records the local Syslog file
holds before wrapping around