User's Manual
Table Of Contents
- XS-3900 User’s Guide
- Front Matter
- Table of Contents
- List of Figures
- Introduction
- Installing the XS-3900
- Installation Prerequisites
- Planning Your Installation
- Installation Workflow
- Unpacking the XS-3900
- Installing the XS-3900
- Powering Up the XS-3900
- Establishing Communication with the Array
- Performing the Express Setup Procedure
- The Web Management Interface
- Configuring the XS-3900
- Logging In
- Making Configuration Changes to the XS-3900
- Array Status
- Express Setup
- Network Interfaces
- IAP Interfaces
- SSID Management
- Security
- Users
- Services
- Software
- Tools
- Event Log
- The Command Line Interface
- Establishing a Secure Shell (SSH) Connection
- Basic Commands
- Command Modes
- Selecting Interfaces
- Command Line Keywords
- Interface Selection
- Interface Configuration
- Radio Configuration
- Beacon Information
- System Administration
- System Testing
- Security
- Station Timeouts
- SSID Configuration
- DNS Configuration
- NTP Configuration
- DHCP Configuration
- Syslog Configuration
- SNMP Configuration
- Filters
- Radius Configuration
- Reports
- Data Handling
- Data Clearance
- Show Information
- Remove Configuration
- Help
- Appendix A: Quick Reference Guide
- Appendix B: Technical Support
- Glossary of Terms
- Index
Wireless LAN Array
158 The Command Line Interface
radius-secret
radius-server
reauth-period
server
Reports
The following keywords are used for generating reports.
assoc
clear
Description: Define the Radius shared secret
Usage: radius { radius-server { configure { radius-secret <radsecret> }}}
Parameters: <radsecret> specifies the Radius shared secret
Description: Configure the Radius server
Usage: radius { radius-server { configure { radius-ip <radip> }}}
Parameters: <radip> specifies the IP address of the Radius server
Description: Specify the elapsed time before allowing a client station to
reattempt authentication
Usage: radius { radius-server { dot1x { reauth-period <reauthper> }}}
Parameters: <reauthper> specifies the amount of time (in seconds) after a
timeout you wait before allowing a client station to retry
authentication
Description: Use the “reauth-period” configured in the RADIUS server
Usage: radius { radius-server { dot1x { server }}}
Parameters: none
Description: Discover the number of devices associated with this XS-3900
Usage: reports { assoc }
Parameters: none
Description: Clear all stored values for the selected interface
Usage: reports { clear { GigE <gnum> }}
Parameters: <gnum> defines the gigabit interface number, either 0 or 1