User's Manual
Table Of Contents
- XS-3900 User’s Guide
- Front Matter
- Table of Contents
- List of Figures
- Introduction
- Installing the XS-3900
- Installation Prerequisites
- Planning Your Installation
- Installation Workflow
- Unpacking the XS-3900
- Installing the XS-3900
- Powering Up the XS-3900
- Establishing Communication with the Array
- Performing the Express Setup Procedure
- The Web Management Interface
- Configuring the XS-3900
- Logging In
- Making Configuration Changes to the XS-3900
- Array Status
- Express Setup
- Network Interfaces
- IAP Interfaces
- SSID Management
- Security
- Users
- Services
- Software
- Tools
- Event Log
- The Command Line Interface
- Establishing a Secure Shell (SSH) Connection
- Basic Commands
- Command Modes
- Selecting Interfaces
- Command Line Keywords
- Interface Selection
- Interface Configuration
- Radio Configuration
- Beacon Information
- System Administration
- System Testing
- Security
- Station Timeouts
- SSID Configuration
- DNS Configuration
- NTP Configuration
- DHCP Configuration
- Syslog Configuration
- SNMP Configuration
- Filters
- Radius Configuration
- Reports
- Data Handling
- Data Clearance
- Show Information
- Remove Configuration
- Help
- Appendix A: Quick Reference Guide
- Appendix B: Technical Support
- Glossary of Terms
- Index
Wireless LAN Array
166 The Command Line Interface
dot1x
encryption
holdoff-time
http-port
http-server
ip
Description: Make the “no” command specific to 802.1x components
Usage: no { dot1x { client-timeout }}
Parameters: none
Description: Disable all encryption
Usage: no { dot11 { encryption }}
Parameters: none
Description: Set to default the amount of time to wait for client
authentication
Usage: no { dot11 { holdoff-time }}
Parameters: none
Description: Set the HTTP port to the default value of 80
Usage: no { ip { http-port }}
Parameters: none
Description: Disable internal Web services (the Web-based configuration
will be disabled)
Usage: no { ip { http-server }}
Parameters: none
Description: Define IP’s to apply the no (removal) command
Usage: no { ip { dhcp-server }}
Parameters: none