User's Manual
Table Of Contents
- XS-3900 User’s Guide
- Front Matter
- Table of Contents
- List of Figures
- Introduction
- Installing the XS-3900
- Installation Prerequisites
- Planning Your Installation
- Installation Workflow
- Unpacking the XS-3900
- Installing the XS-3900
- Powering Up the XS-3900
- Establishing Communication with the Array
- Performing the Express Setup Procedure
- The Web Management Interface
- Configuring the XS-3900
- Logging In
- Making Configuration Changes to the XS-3900
- Array Status
- Express Setup
- Network Interfaces
- IAP Interfaces
- SSID Management
- Security
- Users
- Services
- Software
- Tools
- Event Log
- The Command Line Interface
- Establishing a Secure Shell (SSH) Connection
- Basic Commands
- Command Modes
- Selecting Interfaces
- Command Line Keywords
- Interface Selection
- Interface Configuration
- Radio Configuration
- Beacon Information
- System Administration
- System Testing
- Security
- Station Timeouts
- SSID Configuration
- DNS Configuration
- NTP Configuration
- DHCP Configuration
- Syslog Configuration
- SNMP Configuration
- Filters
- Radius Configuration
- Reports
- Data Handling
- Data Clearance
- Show Information
- Remove Configuration
- Help
- Appendix A: Quick Reference Guide
- Appendix B: Technical Support
- Glossary of Terms
- Index
Wireless LAN Array
22 Installing the XS-3900
RF Patterns
The XS-3900 allows you to control—automatically or manually—the pattern of
wireless coverage that best suits your deployment needs. You can choose to
operate with full coverage, half coverage, or custom coverage (by enabling or
disabling individual sectors).
Full (Normal) Coverage
In normal operation, the XS-3900 provides a full 360 degrees of coverage.
Figure 10. Full (Normal) Coverage
Half Coverage
If installing a unit close to an exterior wall, you can deactivate half of the radios to
prevent redundant signals from “bleeding” beyond the wall and extending
service into public areas. The same principle applies if you want to restrict service
to an adjacent room within the site.
Figure 11. Adjusting RF Patterns
outside wall