User's Manual
Table Of Contents
- XS-3900 User’s Guide
- Front Matter
- Table of Contents
- List of Figures
- Introduction
- Installing the XS-3900
- Installation Prerequisites
- Planning Your Installation
- Installation Workflow
- Unpacking the XS-3900
- Installing the XS-3900
- Powering Up the XS-3900
- Establishing Communication with the Array
- Performing the Express Setup Procedure
- The Web Management Interface
- Configuring the XS-3900
- Logging In
- Making Configuration Changes to the XS-3900
- Array Status
- Express Setup
- Network Interfaces
- IAP Interfaces
- SSID Management
- Security
- Users
- Services
- Software
- Tools
- Event Log
- The Command Line Interface
- Establishing a Secure Shell (SSH) Connection
- Basic Commands
- Command Modes
- Selecting Interfaces
- Command Line Keywords
- Interface Selection
- Interface Configuration
- Radio Configuration
- Beacon Information
- System Administration
- System Testing
- Security
- Station Timeouts
- SSID Configuration
- DNS Configuration
- NTP Configuration
- DHCP Configuration
- Syslog Configuration
- SNMP Configuration
- Filters
- Radius Configuration
- Reports
- Data Handling
- Data Clearance
- Show Information
- Remove Configuration
- Help
- Appendix A: Quick Reference Guide
- Appendix B: Technical Support
- Glossary of Terms
- Index
Wireless LAN Array
30 Installing the XS-3900
Port Failover Protection
To ensure that service is continued in the event of a port failure, you can utilize all
three XS-3900 ports (Fast Ethernet, Gigabit 1 and Gigabit 2) simultaneously.
Figure 22. Port Failover Protection
Switch Failover Protection
To ensure that service is continued in the event of a switch failure, you can
connect XS-3900 units to more than one Ethernet switch.
Figure 23. Switch Failover Protection
#
Gigabit Ethernet connections must be on the same subnet.
Ethernet switch
Multiple port connections
Ethernet switch
Backup switch
Ethernet connections