User's Manual
Table Of Contents
- XS-3900 User’s Guide
- Front Matter
- Table of Contents
- List of Figures
- Introduction
- Installing the XS-3900
- Installation Prerequisites
- Planning Your Installation
- Installation Workflow
- Unpacking the XS-3900
- Installing the XS-3900
- Powering Up the XS-3900
- Establishing Communication with the Array
- Performing the Express Setup Procedure
- The Web Management Interface
- Configuring the XS-3900
- Logging In
- Making Configuration Changes to the XS-3900
- Array Status
- Express Setup
- Network Interfaces
- IAP Interfaces
- SSID Management
- Security
- Users
- Services
- Software
- Tools
- Event Log
- The Command Line Interface
- Establishing a Secure Shell (SSH) Connection
- Basic Commands
- Command Modes
- Selecting Interfaces
- Command Line Keywords
- Interface Selection
- Interface Configuration
- Radio Configuration
- Beacon Information
- System Administration
- System Testing
- Security
- Station Timeouts
- SSID Configuration
- DNS Configuration
- NTP Configuration
- DHCP Configuration
- Syslog Configuration
- SNMP Configuration
- Filters
- Radius Configuration
- Reports
- Data Handling
- Data Clearance
- Show Information
- Remove Configuration
- Help
- Appendix A: Quick Reference Guide
- Appendix B: Technical Support
- Glossary of Terms
- Index
Wireless LAN Array
40 Installing the XS-3900
Installing the Mounting Plate
If necessary, orient the mounting plate (see “Attaching the T-Bar Clips” on
page 39) and locate the plate on the four screw posts. Secure the mounting plate
to the four clamps using the nuts provided. Once the mounting plate is secured,
cut an access hole in the ceiling tile for the cables.
Figure 26. Installing the Mounting Plate
Tile grid
Mounting Plate
Cut an access hole here