User's Manual Part 2

Wireless LAN Array
The Command Line Interface 173
SEE ALSO
None.
iap
DESCRIPTION
Changes the configuration of a specific Integrated Access Point (IAP) radio
interface—available from the config-interface command mode. Groups of
interfaces can be accessed via the following interface commands.
z iap number: Configuration for a specific IAP. The prompt will change
to: IAP number (config-iap-a12)#.
z global_a_settings: Common configuration for all 802.11a IAPs.
The prompt will change to: (config-iap-global-a)#.
z global_bg_settings: Common configuration for all 802.11b/g IAPs.
The prompt will change to: (config-iap-global-bg)#.
z global_settings: Common configuration for all IAPs. The prompt will
change to: (config-iap-global)#.
S
YNTAX
interface iap <IAP number> {channel <cnum> | description <dot11desc> |
down | up | cellsize {small | medium | large} | rx-threshold <thresrx> |
tx-power <powertx>} }
P
ARAMETERS
cellsize Cell size setting
channel Channel number
description Name to identify this IAP (up to 32 characters)
down Shut down (disable) this IAP
rx-threshold Deferred threshold (receive sensitivity)
tx-power Maximum transmit power
up Bring up (enable) this IAP
dot11a Set 802.11a mode
dot11bg Set 802.11b/g mode (only available on abg1, 2, 3, 4)
antenna Select the antenna for the IAP
internal Internal directional 2.4GHz antenna