User's Manual Part 2

Wireless LAN Array
The Command Line Interface 175
iap global_settings
DESCRIPTION
Makes global configuration changes to all Integrated Access Point (IAP)
radio interfaces—available from the config-interface command mode.
This command allows configuration changes to all IAP interfaces. Other
global settings can be made for specific groups of IAPs by using one of the
below parameters in the interface IAP command mode:
z iap number: Configuration for a specific IAP. The prompt will change
to: IAP number (config-iap-a12)#
z global_a_settings: Common configuration for all 802.11a IAPs. The
prompt will change to: (config-iap-global-a)#
z global_bg_settings: Common configuration for all 802.11b/g IAPs.
The prompt will change to: (config-iap-global-bg)#
z global_settings: Common configuration for all IAPs. The prompt will
change to: (config-iap-global)#
S
YNTAX
iap global_settings {all_down | all_up | [no] rogue_detect [ on | off |
add <ssa> {approved | known} | del <ssd> | list ] | auto_channel
[no][power_up [ on | off ] | schedule [<ts>]] | long-retries <lrl> | short-
retries <srl> | cellsize {small | medium | large} | rx-threshold <thresrx> |
tx-power <powertx> | beacon-rate <brate> | beacon-dtim <bdtim> |
inactive-time <at> | reauth-period <ht> | led {disable | enable {iap_up |
associated}} | led_activity {beacon | tx_data | rx_data | tx_mgmt |
rx_mgmt | broadcast | probe_req | assoc}}
P
ARAMETERS
led Enable or disable the IAP leds
disable Do not turn IAP leds on
enable Turn an IAP led on when up (default) or when a
station is associated
iap_up Turn an IAP led on when the IAP is up
associated Turn an IAP led on when at least one station is
associated with it