User's Manual Part 2

Wireless LAN Array
180 The Command Line Interface
SEE ALSO
iap global_bg_settings
iap global_settings
show iap all
iap global_bg_settings
DESCRIPTION
Makes global configuration changes to all 802.11bg Integrated Access Point
(IAP) radio interfaces—available via the Config-> Interface command
mode.
This command allows configuration changes to all 802.11bg IAP interfaces.
Other global settings can be made for specific groups of IAPs by using one
of the below parameters in the Interface IAP command mode::
z iap number: Configuration for a specific IAP. The prompt will change
to: IAP number (config-iap-a12)#
z global_bg_settings: Common configuration for all 802.11b/g IAPs.
The prompt will change to: (config-iap-global-bg)#
z global_settings: Common configuration for all IAPs. The prompt will
change to: (config-iap-global)#
S
YNTAX
IAPGlobalBG {all_down | all_up | slot_time {short_slot | long_slot} |
[no] dot11g_protect [on | off] | [no] dot11g_only [on | off] | cellsize {small
| medium | large} | rx-threshold <thresrx> | tx-power <powertx> |
preamble {short_preamble | long_preamble} | auto_channel |
rts-threshold <rtst> | frag-threshold <fragt> | rates {defaults |
optimize_range | optimize_throughput | { basic { <br1> [<br2> [<br3>
[<br4> [<br5> [<br6> [<br7> [<br8> [<br9> [<br10> [<br11>
[<br12>]]]]]]]]]]]} | supported { [<sr1> [<sr2> [<sr3> [<sr4> [<sr5> [<sr6>
[<sr7> [<sr8> [<sr9> [<sr10> [<sr11> [<sr12>]]]]]]]]]]]]}}}}