Data Sheet

©
RVT28AEFNWR00
Rev.1.2
8.2 Block Diagram
Figure 6. FT800 Block diagram
8.3 Host interface SPI mode 0
Figure 7. SPI timing diagram
For more information about FT801 controller please go to official FT800 Datasheet.
http://www.ftdichip.com/Support/Documents/DataSheets/ICs/DS_FT800.pdf
8.4 Backlight driver block diagram
Backlight enable signal is internally connected to FT800 Backlight control pin. This pin is controlled by
two FT800’s registers. One of them specifies the PWM output frequency, second one specifies
the duty cycle. Refer to FT800 datasheet for more information.
Figure 8. Backlight driver block diagram
FT800