Instructions / Assembly

GR2045401-RG-00/GR2045406-RG-00 21 of 27 20150831-Ver1
LIGHTING THE MAIN BURNER OF GRILL
1. Before each use, check all hoses for cracks, nicks, cuts, burns or abrasions. If a hose
is damaged in any way, do not use your grill before replacing the hose with an
authorized part from the Parts List. Also make sure all gas supply connections are
securely tightened.
2. For optimum performance this grill should be used only when outdoor temperatures
are 60 degrees or above.
3. Familiarize yourself with the Safety and Use and Care instructions in this manual. Do
not smoke while lighting grill or checking gas supply connections.
4. Be sure each LP Gas tank is filled, and lock Casters to prevent movement during grill
operation.
5. Open the left and right Lids before lighting the grill.
6. Check that the end of each Burner Tube is properly located over each Valve Orifice.
7. Set all Control Knobs to OFF and open the propane gas tank valve SLOWLY 1/4 of a
turn.
8. Light the “IGNITION BURNER” first, push and turn the left Control Knob to HIGH
position.
9. Immediately press the Electric Igniter for 3-4 seconds to light the Burner.
10. If ignition does not occur in 5 seconds, turn the “IGNITION BURNER” Control Knob
and gas source OFF and conduct a leak test of ALL gas connections and gas sources
as explained in the Use and Care section of this manual. If no leaks are detected, wait
5 minutes for any gas to clear and repeat the lighting procedure.
11. After IGNITION BURNER is lit, turn the tank valve SLOWLY one more 1/4 of a turn for
1/2 of one complete turn.
12. Once the IGNITION BURNER is lit, you light all the burners 3,2,1,5 and 6 in that order
by turning its Control Knob to HIGH.
HIGH
OFF
LOW
HIGH
OFF
LOW
PRESS