Installation Guide

STEP 7

1. Screw 4 Cam bolts(A) into the pre-threaded holes of the Middle connection board(1) by hand. Do not over
tighten.
2. Attach the Magnet(D) to the Middle connection board(1) by inserting 2pc Screw(E) through the holes on the
Magnet(D) then tighten to the Top board(1).
STEP 8
1. Place lower cross bars (11) and (12) as pictured above with backside of each part facing towards you.
2. Insert 4 wood dowels(C) into the dowel holes in the end of the Top cross board(13).
3. Attach the Left upper support board(12) to the Top cross board(13) by inserting wood dowels into dowel holes on
the left upper support board(12).
4. Attach the Right upper support board(11) to the Top cross board(13) by inserting wood dowels into dowel holes
on the Right upper support board(11).