Installation Guide

STEP 5
1. Screw 3 cam bolts (A) into cam bolt holes on lower left side panel (2).
2. Attach drawer holder (E) to lower left side panel (2) by inserting 2 screws (D) through holes
on drawer holder (E) then tighten to lower left side panel (2).
3. Attach magnet (M) to lower left side panel (2) by inserting 2 screws (N) through holes on
magnet (M), then tighten to lower left side panel (2).
4. Screw 3 cam bolts (A) into cam bolt holes on lower right side panel (3).
5. Attach drawer holder (E) to lower right side panel (3) by inserting 2 screws (D) through
holes on the drawer holder (E) then tighten to lower right side panel (3).
STEP 6
1. Insert 10 wood dowels (C) into wood dowel holes on lower left and right side panels (2)
and (3).
2. Attach lower left side panel (2) to upper cross bar (5), bottom board (7) and decorative
panel (8) by inserting cam bolts (A) into cam lock holes and inserting wood dowels (C) into
wood dowel holes on end of upper cross bar (5), bottom board (7) and decorative panel (8).
3. Insert 3 cam locks (B) into cam lock holes on upper cross bar (5) and bottom board (7),
rotate clockwise to secure the cam bolts (A) in place.
4. Repeat above steps to assemble lower right side panel (3) to upper cross bar (5), bottom
board (7) and decorative panel (8).