1-10 LTO Sport Oval Racer Instructions

STEP 18 OPEN BAG R5 . INSTALL THE SHORTER FRONT BODY
POSTS WITH 3/8 SCREWS AND ADD BODY POST NUTS.
INSTALL THE LONGER BODY
POSTS IN THE INNER SET OF
HOLES AT THE BACK OF THE
CHASSIS PLATE.
STEP 19 INSTALL THE REAR TIRES
WITH TWO SCREWS EACH FROM
THE DIFF BAG.
INSTALL THE BUSHINGS FROM BAG
6 IN EACH SIDE OF EACH FRONT
TIRE, LUBE THE AXLES WITH LIGHT
OIL, INSTALL THE TIRES AND ADD
LOCKNUTS FROM S2A.
STEP 20 SET YOUR BODY DOWN OVER THE CHASSIS AND MARK THE LOCATIONS FOR THE BODY POSTS
AND WHEEL CUTOUTS. YOU CAN CUT THE BODY OUT AND FIT IT OR JUST MARK IT ON THE OUTSIDE ,
PAINT IT AND THEN TRIM AND FIT IT. LEAVE THE PROTECTIVE FILM ON AS LONG AS POSSIBLE . YOU CAN
REMOVE THE TIRES TO MAKE IT EASIER TO INSTALL THE RADIO GEAR IF YOU PREFER.
STEP 21 INSTALL YOUR SERVO SAVER ON THE SERVO YOU
HAVE CHOSEN. WE PROVIDE SERVO TAPE TO ATTACH THE
SERVO TO THE CHASSIS. ALWAYS WIPE BOTH SURFACES BE-
FORE APPLYING THE TAPE. THE OUTPUT ARM OF THE SERVO
SHOULD BE IN THE CENTER OF THE CHASSIS AND SET SO
THE LINKAGE RUNS STRAIGHT OUT TO THE STEERING
BLOCKS. SET THE SERVO IN PLACE AND SET UP YOUR LINK-
AGE BY INSTALLING LINK RODS FROM BAG 6 IN THE SERVO
SAVER AND STEERING BLOCKS AND JOINING THEM WITH SET
COLLARS. MARK WHERE THE SERVO GOES , REMOVE THE
LINKAGE AND USE THE TAPE TO ATTACH THE SERVO , THEN
ATTACH THE LINKAGE AND ALIGN THE STEERING BLOCKS.
STEP 22 INSTALL YOUR BATTERY
PACK IN PLACE ON THE LEFT SIDE
OF THE CHASSIS WITH SUPPLIED TIE
STRAPS OR NYLON REINFORCED
TAPE.
USE SERVO TAPE TO ATTACH YOUR
RECEIVER AND ESC ON THE OPPO-
SITE SIDE OF THE CHASSIS. CONNECT
YOUR WIRES AND TAPE THE EXCESS
IN PLACE TO KEEP IT FROM GETTING
UNDER THE CHASSIS. WE PROVIDE AN
ANTENNA MOUNT , SCREW, AND A
COUPLE OF HOLES IN THE CHASSIS
TO ATTACH IT IF NEEDED. WHERE YOU
MOUNT THE RADIO GEAR WILL DE-
PEND ON THE SIZE OF THE GEAR
THAT YOU HAVE PURCHASED.
4