Instruction manual

8. USAGE EXAMPLE
IMR01Y06-E6
91
Continued from the previous page.
Continued on the next page.
M1
When Measured value (PV)/Manipulated
output value (M1) is transferred to
Manipulated output value (M1).
MOV W2 D2
Store the Manipulated output value
(MV1) of controller 1 into the data
register D2.
Store the Extension area for display
(W002: RWr2) of controller 1 into the
data register D2.
MOV W3 D3
Store the Manipulated output value
(MV1) of controller 2 into the data
register D3.
Store the Extension area for display
(W003: RWr3) of controller 1 into the
data register D3.
FF M1
Measured value (PV)/Manipulated
output value (M1) is inversely
transferred. Variables to be read are
alternately selected.
RST M0
Turn off the Extension number setting
flag for display (M0).
Set the extension number for setting.
Extension number 3: Turn on the
extension number setting Bit 0 (Y1006:
RY06) for set value (SV) setting.
Turn on the Extension number setting
Bit 1 (Y1007: RY07)
M2
When a set of setting extension numbers a
r
e not processed yet.
Extension number setting flag for setting (M2) OFF
Set “150 °C” to Set value (SV) of
controller 1.
Write “150” for Extension area setting
(W102: RWw2) of controller 1.
MOV K150 W102
SET Y1006
SET Y1007
Set “200 °C” to Set value (SV) of
controller 2
Write “200” for Extension area setting
(W103: RWw3) of controller 2
MOV K200 W103
Only the
b
its (Bit 0 and Bit 1)
necessary forsetting extension
number 3 are specified. Any
unspecified bit is assumed to be
the register initial value, 0.