Operation Manual

２
1.2 Installation procedure
1. Drilling mounting hole: Mark the hole position in the mounting wall, drilling 3 holes by a Φ5mm drill, the
depth of the hole is not less than 30mm, and then insert the wall plugs to the hole.
2. Fixing the wifi camera: using the PA4 screw to fix the camera base to the mounting wall. As show in figure
2-2 .
Figure 2-2 fixing the wifi camera
3. Adjust the 3-axis bracket: loosen the locking screw for the bracket and then adjust the bracket. By adjusting
the shaft connection between bracket and the base to realize the direction adjustment. Horizontal (P) 0-360
degree, vertical (T) 0-90 degree, and rotating(R) 0-360 degree. Tightening the screw when it reach the
appropriate scene. As show in figure 2-3.
Figure 2-3 3-axis bracket adjustment