User Manual

TND
™
Tablet User Manual 17
3B. Settings
Route Preferences Options Route Preferences Options
Note: The default settings for your device are already optimized for
truck routing. Use the options below to fine-tune these settings.
A route may still include a roadway or maneuver set to Avoid if the
only legal route found contains these types of roads or the route is
over several hundred miles.
Truck ETA Adjustment Increase ETA more (by 15%)
Increase ETA some (by 5%)
ETA ok
Decrease ETA some (by 5%)
Decrease ETA more (by 10%)
Set adjustments to your ETA due to
weather or traffic conditions. You can
add (increase) time to make the trip
take longer or subtract (decrease) time
to make the trip take less time.
Recalculation Manual recalculate
Auto recalculate
Route Fastest route
Shortest route
Freeways Allow all (default)
Avoid freeways
Prefer freeways
Avoid small roads
Tollways Allow tollways
Avoid tollways
U-Turns Allow u-turns
Avoid u-turns
Ferries Allow ferries
Avoid ferries
Cross-Country Borders Allow cross borders
Avoid cross borders
Dirt Roads Allow dirt roads
Avoid dirt roads
Tunnels Allow tunnels
Avoid tunnels
Manage Avoid List Roads
States/Provinces
Areas
Routes
To avoid a state or province select it from
this list. Tap on the map and select a road,
area, or route to add it to the Avoid List. Tap
the x to remove. (See page 31.)
Fast Recalc Off
On
Fast recalc calculates a route to a midpoint
between your location and the destination,
rather than recalculating the entire route
from scratch. Best used on a long route
that has short distances between
intersections.
Turn Announcements Set three distances at which you want
to be warned about an upcoming turn.
The first announcement will be the farthest
from the turn and the third the closest to
it.
Turn View Distance Set the distance before the maneuver at
which the local street turn view screen
appears. (Note: In 3D map view, this
warning is not needed and will be
turned off.)
Junction View Distance Set the distance before the maneuver
at which the highway junction view
screen appears.