User's Manual

5
Tire Pressure Monitoring System User Manual
Install the Tire Sensors
To install the tire sensors:
1. Unscrew the valve cap on the tire infl ation stem.
2. Screw the locking nut on to the tire infl ation stem. (Optional: The locking nuts prevent
the sensors from being removed without the included hex wrench.)
3. Screw the sensor on to the top of its corresponding tire infl ation stem. Each sensor has
an identifi cation label (LF, LR, RF, RR) that corresponds to a specifi c tire.
LF: left front RF: right front
LR: left rear RR: right rear
4. Use the wrench to tighten the locking nut up against the sensor.
5. Check for air leaks. Fill a spray bottle with soapy water and spray the area. If there is a
leak, air bubbles will escape.
6. Repeat this procedure for the remaining three tires.