User's Manual

Tire Pressure Monitoring System User Manual

Pair the Receiver with Your Tablet or Smartphone

To pair the TPMS receiver with your tablet or smartphone:

1. Press and hold SET on the receiver to turn it on. A blue light will display. The tire sensor

status bar will ﬂash red and the transmitter will begin to beep. (The beeping noise will

stop after several seconds, but the red light will continue to ﬂash.) The receiver must be

on to receive alerts and/or view the tire pressure on your smartphone or tablet.

2. From your tablet or smartphone, open the settings screen and tap Bluetooth.

TPMS should display under available devices.

3. Tap TPMS. A bluetooth pairing request screen will display.

4. Enter the PIN 1234 and tap OK to complete the pairing request.

NOTE: After the receiver is paired with your tablet or smartphone, it will automatically

transmit information whenever both devices are on and Bluetooth is enabled. You will not

need to pair the devices again unless you unpair them.

NOTE: TBD charging receiver.