Users Manual

RM2TRACK-1-0 | ADVANCED SUPPLY CHAIN TRACKING TECHNOLOGY
© System Loco Ltd. 2020
10. Product Certification
This product is certified to the following standards
 EN-60950
 EN 300 328
 EN 301 511
 EN 301 908-1 and EN 30198-1-13
 EN 62311
 EN 301 489-1, EN 301 489-17, EN 301 489-19 and EN 301 489-52
 EN 55032 and EN 55035
 FCC Part 15B
11. Regulatory Information
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC ID: XXXXXXXXXXXXXXX
FCC statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
 Consult the dealer or an experienced radio/TV technician for help.
NOTE: Any changes or modifications not expressly approved by the grantee of this device could void
the user's authority to operate the equipment.