Installation Guide

J1, J2WP, J6-RC, J6SSP, J10, J10SSP
MAINTENANCE INSTRUCTIONS
REPLACING COIN MECHANISM
(1) Remove hex wrench.
(2) Turn out hex screw under handle in front of
door and remove handle.
(3) Open door, remove coin mechanism at bottom
and “spring out” of door.
(4) Reverse above procedure to reinstall
mechanism and handle in that order.
(5) Be sure to replace hex wrench when nished.
REPLACING INSIDE DELIVERY
MECHANISM
(1) To remove either napkin or tampon inside
delivery mechanism, turn roll pin so red side is
down on the mechanism to be removed.
Then, push spring while lifting on the
mechanism. (Follow same procedure to
remove pantyshield mechanism on J10).
(2) The feminine inside delivery mechanism must
be installed on the left. The tampon inside
delivery mechanism must be installed on the
right. (The pantyshield mechanism must be
installed in the middle column on the J10).
(3) To install inside delivery mechanism, rst
turn roll pin red side down. Insert delivery
mechanism in supporting brackets on back
side of front cross brace. Press down until it
snaps into position. Turn roll pin so red side
is up.
IMPACT PRODUCTS, LLC
2840 CENTENNIAL ROAD
TOLEDO, OHIO 43617-1831 USA
impact-products.com
(Revised 9/5/17)
VNDRINS1709