Specifications

2-4
Switch 8
This switch is used to program a new unlock number. Set switch 8 to ON. The voice
will say: "ENTER CONTROL." After the seven-digit unlock number is entered, set switch
8 to OFF.
This switch is also used to activate the CAT-1000B computer interface. This permits
programming of the CAT-1000B through the RS-232 serial port. Set dipswitch 8 to ON
and apply power to the CAT-1000B. After the power up message is complete, the CAT-
1000B will automatically switch to the computer terminal programming mode. This RS-
232 port is configured for a baud rate of 4800. A special cable must be fabricated,
see Figure 7-2.
DTMF Command Table
The following table describes the DTMF commands accepted by the CAT-1000B through the
second RF port. A [Y] means the command will be accepted. A [N] means the command
will not be accepted. Four sets of conditions can exist in the Link and Remote Base
modes. They are:
1 = Link Off - Bridge Down 4 = Link On - Bridge Up
2 = Link On - Bridge Down 5 = Link On - Macro Up
3 = Link Off - Bridge Up
DTMF Commands Entered
Through RF #2 Interface
Control
Receiver
Link
Backbone
Remote
Base
Dual
Repeater
1 2 3 4 5 1 2 3 4 5
Programming Y N N Y Y N N N - Y N Y
Control Y N N Y Y N N N - Y N Y
Macro Y N N N N Y N N - N Y Y
Memory Recall Y N N N Y N N N - Y N Y
DTMF Generator Y N N N Y N N N - Y N Y
DTMF Access Y N N N Y N N N - Y N Y
DTMF Pad Test Y N N N Y N N N - Y N Y
Time of Day Y N N N Y N N N - Y N Y
Link Control N Y Y Y Y Y Y Y - Y Y Y
Bridge Command N Y Y Y Y Y N Y - Y Y N
Link Frequency Load N N N N N N N N - N N N
User Switch Control Y N N N Y N N N - Y N Y
Autopatch Y N N N N N N N - N N Y
Speed Dial Y N N N N N N N - N N Y
Voice Message Select Y N N N Y N N N - Y N Y
DVR Track Select Y N N N Y N N N - Y N Y
Paging Tones Y N N N Y N N N - Y N Y
Reverse Autopatch N N N N N N N N - N N Y
HF Transceiver Control N N N N N N N N - N N N