Specifications
3-5
2. Repeater ID #2 (Active) Enable
When this channel is enabled, the Repeater ID Message #2 will repeat subject to the
setting of the ID timer. This ID will consist of up to 31 words selected from the
voice vocabulary table and is programmed with the [*3102] command. When Repeater ID
#1 and #2 are enabled, ID messages selection will be determined by whether the
repeater is at rest or a QSO is in progress.
3. Squelch Tail Message #1 Enable
When this channel is enabled, the voice squelch tail message #1 will occur when a
repeater user un-keys their transmitter. This message will repeat subject to the
setting of the squelch tail message timer. This message will consist of up to 31
words selected from the voice vocabulary table and is programmed with the [*3103]
command.
4. Squelch Tail Message #2 Enable
When this channel is enabled, the voice squelch tail message #2 will occur when a
repeater user un-keys their transmitter. This message will repeat subject to the
setting of the squelch tail message timer. This message will consist of up to 31
words selected from the voice vocabulary table and is programmed with the [*3104]
command. When Squelch Tail Message #1 and #2 are enabled, the messages will
alternate.
5. Dropout Message #1 Enable
When this channel is enabled, the voice drop out message #1 will occur just before the
repeater transmitter turns off. This message will repeat subject to the setting of
the drop out message timer. This message will consist of up to 31 words selected from
the voice vocabulary table and is programmed with the [*3105] command.
6. Dropout Message #2 Enable
When this channel is enabled, the voice drop out message #2 will occur just before the
repeater transmitter turns off. This message will repeat subject to the setting of
the drop out message timer. This message will consist of up to 31 words selected from
the voice vocabulary table and is programmed with the [*3106] command. When Dropout
Message #1 and #2 are enabled, the messages will alternate.
7. Time of Day Request Enable
When this channel is enabled, repeater users can request a time of day announcement by
entering the time of day request number. This message will consist of up to 31 words
selected from the voice vocabulary table and is programmed with the [*3107] command.
When the CAT-1000B is initialized, this message defaults to: "THE TIME IS 7:15 PM."
8. Grandfather Clock Enable
When this channel is enabled, the CAT-1000B will announce the time of day every hour
on the hour. This message will consist of up to 31 words selected from the voice
synthesizer vocabulary table and programmed with the [*3108] command. When the CAT-
1000B is initialized, this message defaults to: "CAT-1000B REPEATER THE TIME IS 7:15
PM."
Zone 4 Autopatch
1. Autopatch Enable
This channel must be enabled for the controller to process a manually dialed autopatch
request.
2. Autopatch Timer Enable
Autopatch timeout is user programmable with the [*611*] and [*612*] timer programming
commands. When the CAT-1000B is initialized the autopatch timer defaults to 3
minutes and the autopatch activity timer defaults to 30 seconds. When this channel is
turned off, the autopatch will not time-out.