Specifications

3-6
3. Long Distance Enable
During an autopatch, the CAT-1000B counts the number of entries. Numbers in excess of
eight digits are considered a long distance call or an error in dialing. The
controller will immediately terminate the autopatch. When this channel is enabled,
phone numbers with more than eight digits will be accepted.
4. Emergency 911 Enable
This channel must be enabled to process Emergency 911 requests. The controller
examines all three-digit entries. When this channel is enabled, 911 calls will be
permitted. The autopatch access code must precede 911.
5. Speed Dial Enable
This channel must be enabled for the controller to process Speed Dial requests. A
user can access any speed dial location. The voice will say: "CALL TO W4XYZ", delay
two seconds and then dial the phone number stored at that location. Space is provided
for three hundred user phone numbers with call letter ID. Space is provided for ten
public service phone numbers with identifications. A user can access any emergency
speed dial location. Example: the voice will say: "CALL TO FIRE DEPARTMENT," delay
two seconds and then dial the phone number stored at that speed dial location.
6. Phone Number Read Back Enable
This channel will enable phone number read-back prior to dialing. After the repeater
user enters the number, the CAT-1000B will read-back the number for verification. If
the number was entered correctly, the repeater user does nothing and in two seconds
the CAT-1000B will redial the number. If the number is incorrect, the repeater user
enters the autopatch disconnect code during the two second period and the call will be
terminated. To temporarily suspend the phone number read back, key-up when the voice
says: "AUTOPATCH".
7. Autopatch Radio Mute Enable
When this channel is enabled, during an autopatch, mobile audio will go directly to
the telephone line and not be broadcast on the transmitter. A series of beeps will be
heard on the output when the mobile is transmitting. This feature provides a measure
of privacy during an autopatch.
8. Autopatch Pre-Dial
When this channel is enabled the CAT-1000B will generate the number stored in the pre-
dial buffer," before regenerating the actual telephone number. This feature is
useful when the CAT-1000B is connected to a business phone system and a special number
is requires to access an outside line. This feature is limited to manually dialed
numbers. Use the [*89] programming command to enter a new pre-dial number of up to
seven digits.
Zone 5 Autopatch
1. Autopatch Pulse Dial
During normal operation, telephone number regeneration is by DTMF tones. If the
controller is connected to a telephone line that does not accept DTMF inputs, the
controller will pulse dial when this channel is enabled.
2. Reverse Autopatch Enable
This channel must be enabled for the controller to process a reverse autopatch. Call
the repeater by phone, enter the reverse autopatch prefix number followed by the group
number (1), (2) or (3) and the speed dial table position number for that group.
Terminate the entry with the [#]. The controller will generate a ringing type tone
and the voice will say: "CALL FOR W4XYZ." The radio user need only enter the reverse
autopatch prefix number to complete the autopatch.