Specifications

3-7
3. Long Distance Dial (1) Enable
When this channel is enabled, the CAT-1000B will accept a (1) as the first entry of
the telephone number even when Zone 4 Channel 3 "Long Distance Enable" is not turned
ON. A (0) as the first entry will continue to be locked out.
4. Telephone Off Hook Enable
When this channel is enabled, the CAT-1000B will take the phone off hook, key the
repeater's transmitter and provide an audio path to manually dial a phone number.
5. Telephone Ring Announcer Enable
When this channel is enabled, the CAT-1000B will key-up the transmitter and generate a
ringing tone to indicate the repeater's phone is ringing.
6. Modem Auto Answer Enable
When this channel is enabled, the CAT-1000B will answer the telephone and
automatically activate the modem.
7. DTMF Generator Enable
This channel will enable the DTMF Generator. DTMF commands stored in the CAT-1000B
memory can be accessed by a prefix code followed by the memory table position. The
CAT-1000B will key-up the transmitter and sent the DTMF command. This feature is
similar to the regeneration of DTMF tones during a speed dial autopatch. It is
intended to provide noise and distortion free commands for other repeaters or
equipment in a linking system.
8. DTMF Regenerator Enable
When DTMF muting is enabled and a user wants to pass a DTMF command through the
repeater, the entry must be preceded by a [#]. If the DTMF regenerator is enabled,
the controller will mute the original tones while storing the entry in memory. When
the user un-keys, the controller will regenerating the same DTMF command. Like the
DTMF generator, this feature is intended to provide noise and distortion free tones at
the repeater's output.
Zone 6 Transceiver Control
1. Transceiver Receive Enable
When this channel is enabled, the CAT-1000B will accept the transceiver receive ON
command. This feature permits monitoring of the transceiver without transmitting.
2. Transceiver Transmit Enable
When this channel is enabled, the CAT-1000B will accept the transceiver transmitter ON
command and repeat any signal received by the repeater's receiver on the transceiver's
transmitter. The transceiver's PTT output will follow the repeater's COR input.
3. Transceiver Repeat Enable
When this channel is enabled, and the CAT-1000B is configured for Dual Repeater Mode
with dipswitch #3 on and #4 and #5 off, the second RF port will return to link
operation. PTT #2 will no longer follow PTT #1 but will only be active when COR #1 is
active. Also, PTT #2 will never be active when COR #2 is active. This returns RF
port #2 to remote base operation while the dipswitches are still configured for Dual
Repeater operation.
4. Transceiver CTCSS Enable
When this channel is enabled, in addition to a COR input, a positive logic input from
a CTCSS decoder at J4-3 must be present before the CAT-1000B will recognize an input
from the Transceiver. A COR input by itself will have no affect.