Specifications

4-2
Autopatch Speed Dial Access
Key-up, and enter the speed dial number. Un-key, and the voice will read back the
call letters assigned to that speed dial location, wait two seconds and then dial the
number. Speed dial capacity is three hundred numbers, divided into three groups of
one hundred numbers each. The speed dial code can be any number from one to seven
digits and is user selectable with the [*515* for group 1], [*516* for group 2] and
[*517* for group 3] programming commands. During initialization, the speed dial codes
default to [6 for group 1], [7 for group 2] and [8 for group 3]. The speed dial
number consists of the speed dial code, and two-digit table position 00 through 99.
Autopatch Emergency Speed Dial Access
Key-up, and enter the emergency speed dial number. Un-key, and the voice will read
back the identification assigned to that emergency speed dial location, wait two
seconds and then dial the number. The emergency speed dial code can be any number
from one to seven digits and is user selectable with the *518* programming command.
During initialization the emergency speed dial code defaults to [9]. The emergency
speed dial number consists of the emergency speed dial code followed by the single
digit table position 0 through 9.
Autopatch 911 Access
Key-up, and enter the autopatch access code followed by 911. Un-key, and the voice
will say: "AUTOPATCH 911" wait two seconds and then dial the number.
Autopatch Termination
To terminate the autopatch key-up, enter the autopatch termination code. Un-key, the
autopatch will terminate and the voice will log the time. Example: "AUTOPATCH
COMPLETED AT 7:30PM." The autopatch disconnect code can be any number from one to
seven digits and is user selectable. During initialization the autopatch termination
code defaults to a [#]. The autopatch termination message is stored in voice message
buffer [15] and can be changed with the [*3115] programming command.
Reverse Autopatch
To initiate a reverse autopatch, call the repeater by telephone. When the CAT-1000B
answers the phone a beep will be heard. Enter the reverse autopatch code [800],
followed by the speed dial group number (1), (2) or (3) and the table position in that
group. You must terminate the entry with a [#]) pound. The CAT-1000B will key the
transmitter, generate a ringing tone and the voice will say: "CALL FOR W4XYZ." To
connect the reverse autopatch the mobile operator must key-up and enter [800], the
reverse autopatch code.
Autopatch Timer Extend
If during an autopatch, additional time is needed, key-up and send [*1]. This will
reset the autopatch timer. The voice will say: "AUTOPATCH TIMER RESET."
Last Number Redial
If you attempt an autopatch and your call is not completed, the CAT-1000B has last
number redial. Redial will remain active for a period of ten minutes after the
previous call. To place a last number redial call, key-up and send the autopatch
access code followed by a [*].
Hook Flash
If your repeater's telephone line has "call waiting" service, you can intercept the
incoming call. Key-up and send [*2], the CAT-1000B will place the phone on-hook for
200 milliseconds. This will signal the telephone company to switch the waiting call
onto the repeater's phone line. Key-up and send [*2] to return to the original party.
Autopatch Radio Mute
During an autopatch if additional privacy is required, key-up and send [*3]. This
will mute the radio side audio. For the remainder of the autopatch, cover tones will
be sent when the mobile transmits.