Specifications

4-6
Active Memory Identification
Key-up and enter the memory recall prefix number followed by a 0. Un-key and the
voice synthesizer will read back the memory file number. Example: With memory recall
prefix number of 175, and current memory compares to file 5.
Key-up and enter: 1 7 5 0
└─┼─┘ └──── Memory File Read Back
└──────── Memory Recall Prefix Number.
The voice will say: "FILE ID IS FIVE." If changes were made to active memory and it
no longer agrees with the original file in storage, the voice will say: "FILE FIVE
DATA MODIFIED."
Memory Recall
To copy a memory file into active memory, key-up and enter the memory recall prefix
number followed by the file number to be loaded into active memory. Example: With a
memory recall prefix of 175, move file 3 to active memory.
Key-up and enter: 1 7 5 3
└─┼─┘ └────────Memory File Number
└────────────Memory Recall Prefix Number
User Function Control By Repeater Input
This feature permits repeater users to control the eight user function switches with a
simple DTMF entry. To control one of the switches, Key-up and enter the user function
control number followed by the switch number to be controlled and a [0] to turn the
switch OFF, a [1] to turn the switch ON or a [2] to momentary change the switch for
0.5 seconds. Example: With a user function control number of 550, turn ON switch
five.
Key-up and enter: 5 5 0 5 1
│ │ │ │ └───── Command 0=Off 1=On 2=Change For 0.5 Seconds
└─┼─┘ └─────── User Function Switch Number 1 through 8
└─────────── User Function Control Number
DR-1000 Switch Control By Repeater Input
This feature permits repeater users to control the eight user function switches
located on the DR-1000 digital voice recorder. Key-up and enter the Serial board
prefix number followed by the table location number. The CAT-1000B will change the
settings of the eight switches to conform to the pattern stored by the [*47XX]
programming command. Example: With a prefix number of 580, set the switches to the
conditions previously stored in memory at table position three.
Key-up and enter: 5 8 0 0 3
└─┼─┘ └─┴───── Serial Board Table Location Number
└─────────── Serial Board Switch Prefix Number
Control By Telephone
To control the CAT-1000B, call the repeater by telephone. When the controller
answers, a beep will be heard. Enter the control operator prefix code [100], followed
by a (#) pound. The voice will say: "CONTROL READY." You need only enter the Zone
number, Channel number and a (1) to turn the channel ON or a (0) to turn the channel
OFF followed by the (#) pound. It is not necessary to enter the control operator
prefix number before each command when controlling by phone. To terminate control by
phone send [*0#].
Programming By Telephone
Call the repeater by telephone. When the controller answers, a beep will be heard.
Enter the seven digit unlock number [1234567], followed by a (#) pound. The voice
will say: "CAT-1000B CONTROL." Programming by phone is identical to programming by
radio except you must end each entry with a [#] pound. To terminate programming by
phone send [*0#].