Specifications

5-6
Program Voice Message With Time Variables
To insert the time-of-day into a voice messages load the number [100]. Example: Load
ID #1 with "THE TIME IS [ACTUAL TIME] AND THIS IS THE W4XYZ REPEATER." Other time
variables include: [101 - Day of the Week], [102 - Day and Month] and [103 -
Salutation].
Message Number─┐ ┌─────[Actual Time]
│ │
*31 01 830 838 482 100 231 833 482 830 890 004 920 930 950 746
User Function Control by Voice Message.
The voice message buffers can also control the eight User Function switches. If
during the execution of a voice message, a User Function switch command (111 through
135) is encountered, the CAT-1000B will set the switch and then continue with the
remainder of the voice message.
USER FUNCTION VOICE CONTROL COMMANDS
111 UF#1 OFF 117 UF#3 OFF 123 UF#5 OFF 129 UF#7 OFF
112 UF#1 ON 118 UF#3 ON 124 UF#5 ON 130 UF#7 ON
113 UF#1 MOM 119 UF#3 MOM 125 UF#5 MOM 131 UF#7 MOM
114 UF#2 OFF 120 UF#4 OFF 126 UF#6 OFF 132 UF#8 OFF
115 UF#2 ON 121 UF#4 ON 127 UF#6 ON 133 UF#8 ON
116 UF#2 MOM 122 UF#4 MOM 128 UF#6 MOM 134 UF#8 MON
135 0.5 SEC DELAY MOM = MOMENTARY 0.5 SECONDS
DVR Track Selection by Voice Message
The voice message buffers can be used to select one of the sixteen DVR voice tracks.
If during the execution of a voice message, a DVR track command (140 through 155) is
encountered, the CAT-1000B will play the recorded message stored at that track.
DIGITAL VOICE RECORDER TRACK CONTROL COMMANDS
140 TRACK #1 144 TRACK #5 148 TRACK #9 152 TRACK #13
141 TRACK #2 145 TRACK #6 149 TRACK #10 153 TRACK #14
142 TRACK #3 146 TRACK #7 150 TRACK #11 154 TRACK #15
143 TRACK #4 147 TRACK #8 151 TRACK #12 155 TRACK #16
Courtesy Tone Selection by Voice Message
The voice message buffers can be used to generate courtesy tones. If during the
execution of a voice message, a courtesy tone command (160 through 169) is
encountered, the CAT-1000B will generate the courtesy tone stored at that memory
location.
Load Courtesy Tone Repeater Receiver
Key-up and send [*3111], followed by the three-digit number that represents the
desired courtesy tone. Un-key and the voice will say: "CONTROL OK." Example: Select
courtesy tone #3.
Programming Command──┐ ┌───────Message Number
Command *31 11 163──Courtesy Tone #3
COURTESY TONE CONTROL COMMANDS
160 TONE #0 162 TONE #2 164 TONE #4 166 TONE #6 168 TONE #8
161 TONE #1 163 TONE #3 165 TONE #5 167 TONE #7 169 TONE #9