Specifications

5-10
DTMF Access Number [*505*]
When the repeater is in the DTMF Access Mode it will not respond to a COR input. The
repeater user must enter a DTMF access number to activate the repeater. When the
repeater returns to rest for a period determined by the sleep timer, the number must
be re-entered to activate the repeater. Example: To program a DTMF Access Number of
325, key-up and send [*505*325]. Un-key and the voice will say: "CONTROL OK."
DTMF Pad Test Number [*506*]
This number must be entered to initiate a DTMF keypad test. Example: To program a
DTMF Pad Test Number of 375, key-up and send [*506*375]. Un-key and the voice will
say: "CONTROL OK."
Time Request Number [*507*]
This number must be entered to request the time of day announcement. Example: To
program a Time Request Number of 400, key-up and send [*507*400]. Un-key and the
voice will say: "CONTROL OK."
Transceiver Control Number [*508*]
This number must precede the command used to activate or deactivate the transceiver.
Example: To program a Transceiver Control Number of 500, key-up and send [*508*500].
Un-key and the voice will say: "CONTROL OK."
Remote Base Frequency Load Number [*509*]
This number must precede the command used to change the frequency of the serial tuned
remote base transceiver. Example: To program a remote base Frequency Load Number of
525, key-up and send [*509*525]. Un-key and the voice will say: "CONTROL OK."
User Function Switch Number [*510*]
This number must precede the command to change the settings of the user function
switches on the CAT-1000B. Example: To program a User Function Switch Number of 550,
key-up and send [*510*550]. Un-key and the voice will say: "CONTROL OK."
DR-1000 Switch Number [*512*]
This number must precede the command to change the settings of the expanded user
function switches on the DR-1000 board. Example: To program a switch prefix number
of 580, key-up and send [*512*580]. Un-key and the voice will say: "CONTROL OK."
Autopatch Access Number [*513*]
This number must be entered to access the autopatch. Example: To program an
autopatch access number of *, key-up and send [*513**]. Un-key and the voice will
say: "CONTROL OK."
Autopatch Disconnect Number [*514*]
This number must be entered to terminate the autopatch. Example: To program an
autopatch termination number of #, key-up and send [*514*#]. Un-key and the voice
will say: "CONTROL OK."
User Speed Dial Prefix Number (Block #1) [*515*]
This number must be entered to access a user speed dial location. Example: To
program the speed dial prefix 6, key-up and send [*515*6]. Un-key and the voice will
say: "CONTROL OK." This number must precede the block 1 speed dial table location.
With the prefix 6, the speed dial numbers will be 600 through 699.
User Speed Dial Prefix Number (Block #2) [*516*]
This number must be entered to access a user speed dial location. Example: To
program the speed dial prefix 7, key-up and send [*516*7]. Un-key and the voice will
say: "CONTROL OK." This number must precede the block #2 speed dial table location.
With the prefix 7, the speed dial numbers will be 700 through 799.