Specifications

5-11
User Speed Dial Prefix Number (Block #3) [*517*]
This number must be entered to access a user speed dial. Example: To program the
speed dial prefix 8, key-up and send [*517*8]. Un-key and the voice will say:
"CONTROL OK." This number must precede the block #3 speed dial table location. With
the prefix 8, the speed dial numbers will be 800 through 899.
Emergency Speed Dial Prefix Number [*518*]
This number must be entered to access an emergency speed dial location. Example: To
program the speed dial prefix 9, key-up and send [*518*9]. Un-key and the voice will
say: "CONTROL OK." This number must precede the speed dial location number. With the
prefix 9, the speed dial numbers will be 90 through 99.
Voice Demonstration Control Number [*519*]
This number must be entered to PLAY one of the voice messages. This number must
precede the voice message number. Example: To program a Voice Demonstration Control
Number of 700, key-up and send [*519*700]. Un-key and the voice will say: "CONTROL
OK."
DVR Control Number [520*]
This number must be entered to PLAY one of the DVR tracks. This number must precede
the track number. Example: To program a DVR Control Number of 725, key-up and send
[*520*725]. Un-key and the voice will say: "CONTROL OK."
Paging Tone Number [*521*]
This number must be entered to make the CAT-1000B transmit a paging tone. This number
must precede the paging tone memory location. Example: To program a Paging Tone
Number of 750, key-up and send [*521*750]. Un-key and the voice will say: "CONTROL
OK."
Reverse Autopatch Access Number [*522*]
This number must be entered to access the reverse autopatch. Example: To program the
reverse autopatch access number 800, key-up and send [*522*800]. Un-key and the voice
will say: "CONTROL OK." This number must precede the speed dial group and table
position numbers.
HF Remote Base Access Number [*523*]
This number must precede each HF Remote Base command. Example: To program the HF
Remote Base access number 560, key-up and send [*523*560]. Un-key and the voice will
say: "CONTROL OK."
Monitor Repeater By Telephone [*524*]
This number must be entered to monitor the repeater through the telephone. Example:
To program the monitor repeater access number 850, key-up and send [*524*850]. Un-key
and the voice will say: "CONTROL OK."
Reverse DTMF Paging Access Number [*525*]
This number must be entered to access reverse DTMF Paging. Example: To program the
reverse DTMF paging access number 875, key-up and send [*525*875]. Un-key and the
voice will say: "CONTROL OK." This number must precede the pager number.
Read Control Number [*501 - *525]
Key-up and send [*501]. Un-key and the voice synthesizer will read back the Control
Operator Prefix numbers. The voice will say: "PRESET CODE FIVE ZERO ONE IS ONE ZERO
ZERO."