Specifications

5-12
Control Number Table
COMMAND CONTROL NUMBER DESCRIPTION DEFAULT
*501* CONTROL OPERATOR PREFIX 100
*502* LINK BRIDGE CODE 150
*503* MEMORY RECALL PREFIX 175
*504* DTMF GENERATOR PREFIX 300
*505* DTMF ACCESS CODE 325
*506* DTMF PAD TEST CODE 375
*507* TIME OF DAY REQUEST CODE 400
*508* TRANSCEIVER CONTROL PREFIX 500
*509* REMOTE BASE FREQUENCY LOAD PREFIX 525
*510* USER FUNCTION SWITCH PREFIX 550
*512* DR-1000 SWITCH PREFIX 580
*513* AUTOPATCH ACCESS CODE *
*514* AUTOPATCH DISCONNECT CODE #
*515* USER SPEED DIAL PREFIX (BLOCK 1) 6
*516* USER SPEED DIAL PREFIX (BLOCK 2) 7
*517* USER SPEED DIAL PREFIX (BLOCK 3) 8
*518* EMERGENCY SPEED DIAL PREFIX 9
*519* VOICE PREFIX 700
*520* DVR CONTROL PREFIX 725
*521* PAGING TONE PREFIX 750
*522* REVERSE AUTOPATCH CODE 800
*523* HF REMOTE BASE CODE 560
*524* MONITOR REPEATER BY TELEPHONE 850
*525* REVERSE DTMF PAGING CODE 875
Timer Memory
This memory area is reserved for storage of nineteen timers. These timers are user
programmable. If the CAT-1000B is initialize by applying power with dip-switch #7 in
the ON position, the timers will be automatically loaded with default times.
Repeater Time-out [*601*]
The maximum transmission length is limited by the repeater’s time-out timer. This
timer is programmable between 1.0 and 1799 seconds. Example: To program this timer to
2 minutes, key-up and enter [*601*120]. Un-key and the voice will say: "CONTROL OK."
When initialize, this timer will default to 180 seconds.
Repeater Sleep Timer [*602*]
This timer determines the time required for the repeater to be at rest before the DTMF
access code is required to activate the repeater. This timer is programmable between
1.0 and 1799 seconds. When initialize, this timer will default to 60 seconds.
Repeater Turn on Delay Timer [*603*]
When the repeater is at rest, this timer determines the time COR must be present
before the repeater will activate. This timer is programmable between 0.1 and 9.9
seconds. Example: To program this timer to 1.5 seconds, key-up and enter [*603*15].
Un-key and the voice will say: "CONTROL OK." When initialize, this timer defaults to
1.0 second.